One company. All your installations.
Our specialist websitesServices

Office ventilation

Office refurbishment: check ventilation when adding private rooms

Before enclosing rooms in an office, check fresh-air supply, return paths, occupancy and filter access. A practical refurbishment guide.

Red Málaga Instalaciones3 min read

An office may keep its existing air conditioning yet need ventilation changes when partitions are installed. A new private office, meeting room or archive occupies space that was previously connected. Before finishes are completed, check how air enters and leaves each room rather than simply moving a grille to suit the ceiling layout.

Use both the existing and proposed plans

Mark known supply, return and fresh-air ventilation positions on both drawings. Where a grille’s purpose is uncertain, a technician needs to identify it. A ceiling photograph shows the finish but does not establish which duct serves each opening.

Add normal and expected maximum occupancy for each room. A space occasionally used by a group is not fully described by its number of permanent desks. Include doors normally kept closed and different operating hours between areas; these details help assess airflow paths and controls.

Cooling a room does not necessarily ventilate it

Air conditioning may recirculate indoor air to control temperature. Ventilation supplies outside air and removes air from the building according to the designed system. Adding a split unit to an office therefore does not demonstrate that fresh-air requirements have been addressed. Our ventilation and air conditioning guide explains the distinction, while an office needs its own assessment.

Spain’s RITE includes offices within indoor air quality category IDA 2 and sets out methods for determining airflow. A professional must apply the appropriate method and conditions to the premises. Copying a generic airflow-per-square-metre figure from a different activity is not a substitute for that work.

What changes when a partition reaches the ceiling?

It may leave a supply grille inside a room with the return outside, or place both away from the occupied area. The design needs to establish how air continues to move when the door is closed. The arrangement also has to work with acoustic requirements and the building’s conditions.

We do not recommend making improvised openings in doors or partitions. Agree the airflow route with the people designing the layout and installations. When ductwork changes, retain access to components requiring adjustment or cleaning: a decorative grille does not always provide sufficient service access.

Plan a representative check

Before treating the refurbishment as complete, agree what will be checked and under what conditions. Record which rooms are occupied, which doors are closed and how the equipment is operating. A result without that context offers limited help if the meeting room later feels stuffy.

Any measurements required should be interpreted as part of the whole installation. INSST’s guidance on indoor environmental quality recognises different physical, chemical and biological factors. An isolated reading from a domestic sensor does not identify every possible air-quality issue or replace a professional assessment.

Information to prepare for an office quotation

  • Current and proposed layouts, room areas and heights.
  • Activities, occupancy and operating hours for each space.
  • Photographs of accessible grilles, ceilings and units, without dismantling them.
  • Existing air conditioning and ventilation documents, where available.
  • Limits on noise, access, finishes and dates when work can take place.

You can attach plans and photographs through Benalclima’s quote request. Where the refurbishment also involves electrical, plumbing or control systems, Red Málaga can help assess their coordination. An initial review clarifies the scope and the checks needed before the final solution is priced.

Sources and technical reading

CallRequest information ↗